IDS 805, Installer Manual

Page: 14 / 48

14
IDS 805 Installer Manual 700-266-02H Issued September 2009
Table 3: Binary Representation
Value 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Zone 1
(2
0
=1)
               
Zone 2
(2
1
=2)
  

           
Zone 3
(2
2
=4)
               
Zone 4
(2
3
=8)
               

Off

On
12.3 Programming the Panel

For all programming procedures, the [*] (star) key functions as the enter key and the [#] (hash)
key functions as a clear key to clear incorrect or unintended entries, as a backspace and to exit
the programming mode.

If an error has been made, i.e. an attempt is made to enter an illegal value or an incorrect series
of keystrokes, the keypad will beep three times to indicate the error. The panel will automatically
discard the invalid entry allowing the correct entry to be made without manually clearing the
incorrect entry.
Procedure:
1. Ensure that the panel is not armed.
2. Press the [#] key (this will clear any previous or accidental entries) followed by the 4 digit
[INSTALLER CODE] (the default installer code is 9999).
3. If the correct code has been entered, the green READY indicator will begin flashing.
4. Press the [*] key.
5. Enter the [LOCATION NUMBER] of the program location that you wish to change. Location is
displayed in binary.
6. Press the [*] key. The READY indicator will continue flashing and the AWAY indicator will come
on.
7. The zone LED’s will now display the content of the selected program location in binary format
(ref. Table 3).
8. If you wish to change the content of the location, enter the [NEW VALUE] followed by the [*]
key. If you do not wish to change the location value, press the [#] key. The READY indicator will
continue flashing and the AWAY indicator will turn off.
9. If the data value has been changed, the buzzer will give a long beep indicating that a valid entry
has been stored.
10. Repeat steps 5-8 until all necessary locations have been programmed.
11. To exit from the programming mode press the [#] key.
The READY indicator will stop flashing to indicate that the program mode has been exited.