66
IC(PC/SC) : Contact Smartcard Encoding
In SOLID-510 printer, a contact smartcard encoder can be installed and SOLID-510
printer supports the contact smartcard encoder in the printer inside.
“IC(PC/SC)” is to
test a contact smartcard encoding.
“ICH Contact”
is to bring the encoder head into contact with the IC chip of smartcard
physically.
“ICH Discontact”
is
to separate the encoder head from the IC chip of smartcard
physically
.
“Init”
is to recognize and display the installed contact smartcard reader
.
The
recognized encoder will be displayed at the pull down control.
“Contact”
is
to contact with the smartcard electrically and initialize.
“Reset”
is to finish the function electrically.
After “Contact”, you can run “Get ATR”,
“Read”, “Write” and “Clear”.
“Get ATR”
is to read the ATR data.
“Read”
and
“Write”
are
to read and write the defined data (Name, Address and
Phone). These could not be applied to all cards.
“Clear”
is
to clear the displayed data (ATR, Name, Address and Phone).
In case the data is read and written using APDU, Read/Write can be done by APDU
commands.
“Load APDU”
is to read the stored APDU commands.
“Save APDU”
is to save the displayed APDU commands.
“Clear APDU”
is to clear the APDU section.
“Send APDU”
is to run the APDU commands.
Batch process repeats the following steps sequentially,
Card “IN”
Move “IC”
IC
“ICH Contact”
IC “Init”
IC “Contact”
IC “Reset”
IC “ICH Dis-contact”
Card “OUT”.
