43
③
Click “Card Printer” tab.(If laminator or flipper is installed, you can setup laminator
or flipper
setting value by “Laminator” tab or “Flipper” tab..
④
To show firmware version, serial number of printer and serial number, resister &
type of print head.
⑤
To show print area. It shows
exaggeratingly
for user convenience.
⑥
To set print area. Please set it properly to print on an entire card because SOLID-
510 is a direct thermal card printer
. When you click “
⑦
Print”, a card is printed as
like “
④
example”. Please set values properly that all circles of each corner are
printed and blank spaces are 0.4mm ~ 0.5mm in the top and the bottom of a card.
Please set values by following order.
X Start Position:
Please set right and left properly by adjusting X position.
Y Start Position:
Please set the start position of printed example image and
blank space in the top is 0.4mm ~ 0.5mm.
Y End Position:
Please set the end position of printed example image and blank
space in the bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger
value for
“Y scale” than default.
Y Scale:
Please set to show circles in the bottom.
⑦
To set density. SOLID-510 enables to set different density for each color, resin
black and overlay. So, please set each density for high quality. Please optimize
the quality by adjusting each value. To optimize, you repeatedly adjust the density
and print a Calibration card and check the print state until you get the optimum.
Total Density:
To set all of the density (Color, Black and Overlay) at one time.
YMC Density:
To set color density. Please maximize YMC density as you can,
which enables to express range of color and vivid images. If it is too strong, green
or red marks are appeared. If it is too weak, the print quality will be dull.
