GF-100 User
’s Guide
57
10 Setting GF-100
10.1 Source test connector
10.1.1 Requesting input signals
If you change the EDID setting of the GF-100 or restart it while the connected source device is turned on,
some source devices stop outputting signals. In such a case, use this menu to request the source device to
output signals.
Menu
TOP → SETTINGS → VIDEO INPUT → SIGNAL REQUEST
Set value
OFF: The GF-100 does not request to output signals even if the source device stops outputting signals.
1 sec to 30 sec: The GF-100 requests to output signals after the set time if the source device stops
outputting signals. [Default: 20 sec]
10.1.2 Input DC balance
Set this menu if video of the source device cannot be displayed.
Menu
TOP → SETTINGS → VIDEO INPUT → RECV OFFSET
Set value
DISABLE [Default]
ENABLE
10.1.3 HDCP enabled/disabled
Menu
TOP → SETTINGS → VIDEO INPUT → HDCP INPUT
Set value
ACTIVE: [Default]
INACTIVE
