i-Q350 RCM
USER MANUAL
VISIBILITY DELIVERED.
PAGE 6 OF 28
1. SAFETY INSTRUCTIONS
The system described in this manual is for exclusive operation of trained employees. Only qualified personnel
that have knowledge of the potential dangers involved should perform the installation, settings, maintenance
and repair of the units used.
Operational Safety
The correct and safe use of these systems assumes that operating and service personnel follow the safety
measures described in the manual alongside the generally acceptable safety procedures.
If there is a possibility that safe operations cannot be guaranteed, the system must be switched off, secured
against accidental use and the service unit responsible immediately informed.
Safety Documents
The i-Q350 tag was designed, tested and supplied in perfect condition according to document IEC348 Safety
Requirements for Electronic Units of Class 1.
Condensate / Change of Temperature
To avoid condensation in the system, the unit must be allowed to slowly adjust itself to warmer temperatures
after removal from cold and cool environments.
Do not open the housing
There is absolutely no need to open the systems housing during set up. Configuration is done with built in
interface wirelessly.
Earthing
Before establishing any connections the housing of the system must be earthed.
Battery Inside
All system tags contain a battery; therefore the following warning should be heeded:
WARNING
-
Fire, explosion and burn hazard risk of explosion if battery is replaced by an
incorrect type. Do not recharge, short circuit, crush, disassemble, heat above
100 °C (212 °F)
Do not incinerate, or expose contents to water
Fuses
Only experts who are aware of the dangers involved may replace the fuses. It must be ensured that only
fuses of the required current rating and the correct type are used for replacement. The use of repaired fuses
and/or short-circuiting the fuse holders is prohibited.
