12
Filter Replacement
WARNING:
After removing the cover, wait 60 seconds in order to depressurize the filters
before removing the filters. After replacing a filter, discard the first 2 full water
tanks that AquaTru produces.
IMPORTANT: Once you have installed
the new clean filters, you must press the filter reset
button located on the back of the unit. If you do not
do this step, the filter light indicator will stay lit and
the AquaTru will not track the life of the new filter.
Long Term Storage / Vacation
If leaving on vacation, start by switching the unit off. Next, wash both tanks with soap
and water. Allow the tanks to dry thoroughly before reinstalling them. When you have
returned from vacation, purge the system of stagnant water by running 4 full tap water
tanks through the system. Once the fourth tank has been filtered, the unit is ready to
use. This process can be avoided by having a house sitter run one tank of tap water
through the AquaTru at least once a week.
Filter 1-2
| Pre/Carbon Filter (Part#
AT2001
)
Filter 3
| Reverse Osmosis Filter (Part#
AT2002
)
Filter 4
| VOC Carbon Filter (Part#
AT2003
) or
VOC Carbon with pH + Mineral Boost (Part#
AT2004
)
1.
Pivot the filter outward to make it easier to
remove (Figure 1).
2.
Remove old filter by turning it
counter clockwise (Figure 1).
3.
Install new filter by turning it clockwise.
Be sure to tighten securely.
HELPFUL TIP:
If you find it difficult to screw on the filter, wet
the O-ring on the filter housing by holding it
under the cold water faucet for a few seconds.
4.
Pivot the filter back to its vertical
upright position.
5.
Close side panel.
6.
Press the
Filter Reset Button
located
on the back of the AquaTru unit (Figure 2).
Press and hold it for at least
5 seconds,
or until the filter light turns off.
7.
After installing a new filter, always
discard the first two full water tanks
the AquaTru produces.
Figure 1
Figure 2
Cleaning & Maintenance
