8
9.
Fill tap water tank with cold tap water and then reinstall. Be sure that both tanks
are properly seated. This can be done by pressing down on the tanks once in place.
10.
Plug in unit.
11.
Power on the AquaTru using the switch located on the back.
First Time Start-Up Procedure
Run 4 full, unfiltered cold (tap) water tanks through the AquaTru
before drinking.
12.
Once the tanks have been installed on the unit and the unit is turned on, it will
begin to filter water automatically.
Note:
It will take longer than normal for the first tank to go through a cycle. A white
cloud will be visible in the tap water tank.
This is perfectly normal, the white cloud
represents tiny air bubbles released by the RO membrane.
NOTICE: Keep a close eye for any water leaks. In case of a leak, check the
"Troubleshooting" guide on pages 12-13.
13.
AquaTru will stop filtering water when the clean water tank is full or when it is time
to refill the tap water tank.
Note:
When it is time to refill the unfiltered (tap) water tank it will be a quarter full.
WASTER WATER SCALING RISK
AquaTru works by recirculating water many times, leaving concentrated
contaminants in the tap water tank. Therefore, you must discard the waster
water (remaining water in tap thank) before refilling. Failure to discard this highly
concentrated waster water will cause contaminants to form scale on internal parts
and cause product failure.
The water in the tap water tank must be discarded every
time you refill the tap water tank. Failure to do so will
damage the unit and void the warranty.
14.
Empty and rinse both water tanks.
15.
Repeat steps 8-12, 3 more times.
16.
When 4 cycles have been completed, your AquaTru is ready to be used.
Installation
