Chapter 3
Calibration, Configuration, and Special Operations
3-30
To set a Cable ID:
1.
In the Cable ID screen,
highlight
Set ‘Cable From’
.
2.
Press
Enter
to open the screen.
Note: The screen that appears will
reflect the most recently
assigned Cable ID (either
Single or Double). Double ID is
used in this example.
3.
Enter the following parameters
as required:
a.
Cable Name, ten characters
maximum.
b.
Current Value, four
incrementing characters.
c.
Select
to go to the
Cable To
screen. Repeat
steps a and b.
4.
After entering the desired
Cable From
and
Cable To
names and parameters,
press
to save and return to the Main Cable ID screen.
Summary of Contents for LANTEK
