SERVICING
22
Mexico Super CF495 - CF4140
-
Installation & Servicing
29 SCHEDULE
To ensure the continued safe and efficient operation of the
appliance, it is recommended that it is checked at regular
intervals and serviced as necessary. The frequency of
servicing will depend upon the installation condition and
usage but should be carried out at least annually.
It is the law that any service work must be carried out by a
CORGI registered installer. In IE servicing work must be
carried out by a Competent Person.
a.
Light the boiler and carry out a pre-service check,
noting any operational faults.
b.
Clean the main burners and lint gauzes.
c.
Clean the lower front panel lint gauze.
d.
Clean the heat exchanger.
e.
Clean the main injectors.
f.
Check that the flue is unobstructed and that the flue
system, including the flue cleanout cover, is sealed
correctly.
g.
If the appliance has been installed in a compartment,
check that the ventilation areas are clear.
The servicing procedures are covered more fully in Frames
28-35 and MUST BE CARRIED OUT IN SEQUENCE.
WARNING.
Always turn OFF the gas supply at the gas
service cock and switch OFF and DISCONNECT the electrical
supply to the appliance
BEFORE SERVICING.
IMPORTANT.
After completing the servicing or exchange of
components always test for gas soundness, carry out
functional checks as appropriate and test for spillage. Refer
to Frame 26.
Note.
It may be necessary to remove the boiler
casing to carry out the spillage test.
30 BOILER CASING REMOVAL
Thermostat phial
Thermostat pocket
Phial retaining
clip
Split pin
MEX 729
1.
Remove the 2 screws and lift off the lower
front panel.
2.
Remove the 2 screws and lift off the grille
assembly.
3.
Disconnect the in-line connector on the PCB
lead.
4.
Remove the Burner On neon cable from the
back of the control panel.
7.
Remove the 2 screws securing the control panel and
pull down to release the tabs from under the top panel.
8.
If the boiler is not fitted under a work top, access for flue
cleaning will be improved by removing the top panel.
5.
Unplug the in-line connector to the TTB
thermostat.
6.
Remove the thermostat phial from the
pocket as shown.
SER
VICING
200944-1.p65
3/8/2004, 3:41 PM
22
