www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
install guide
Version française disponible en ligne au www.idatalink.com
transponder Bypass
chrysler / dodge / Jeep
Page 3 of 5
ADS-TBSL-C1
20071224
www.idatalink.com
For technical assistance, contact your distributor or visit www.idatalink.com/support
© 2007 ADS Inc.
NOTICE:
the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself
or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill &
knowledge is therefore assumed. please review the installation guide carefully before beginning any work.
12V - RED
GROUND - BLACK
(NC) - NO WIRE
GROUND-OUT WHEN RUNNING - BLUE/WHITE
GREEN - DISARM INPUT
PINK - IGNITION INPUT
YELLOW - STARTER INPUT
PURPLE/BROWN - MULTIPLEX SECOND START
IGNITION
STARTER
MULTIPLEX (PURPLE/BROWN)
WRAP LOOP TIGHTLY AROUND THE
IGNITION CYLINDER
(3 to 5 turns around the ignition
cylinder is usually required for
adequate transponder performance).
SLIDE THE PLASTIC RETAINER UP
TOWARDS THE CYLINDER TO FORM A
TIGHT NOOSE.
ONLY REQUIRED FOR VEHICLE EQUIPED
WITH MULTIPLEX SECOND START (TYPE 2).
CONNECT EITHER
IDATALINK
OR
STANDARD WIRING
IDATALINK
REMOTE
STARTER
IDATALINK (RS232) PORT
REQUIRED ON REMOTE STARTER.
IF UNAVAILABLE USE STANDARD WIRING METHOD
LEGEND
Wiring connections not required
when installed in iDataLink mode
DO NOT CONNECT ANY ADDITIONAL WIRES
AND RELAYS OTHER THEN THE ONE
SPECIFIED IN OUR SCHEMATIC TO CONTROL
MULTIPLEX START/ACCESSORY/KEYSENSE.
TYPE 1 & 2
WIRING DIAGRAM
3. program your module
see instructions below
IMPORTANT NOTICE
the tBsl-c1 can only Be programmed once and only in one vehicle.
1
2
Wrap the loop tightly around the key cylinder 3 to 5 times.
Slide the plastic retainer up towards the cylinder to tighten the noose.
NOTE: It is preferable to place the antenna loop on top or in front of the OEM immobilizer coil.
Connect antenna to the blue connector on iDatalink Module.
NOTE: KEEP TRANSPONDER AWAY FROM ANY METAL SOURCE OR WIRING.
ANTENNA INSTALLATION INSTRUCTIONS
OR
NOT
Doc. No.: ##00195##
