iDataLink ADS-TBSL-C1 Install Manual Download Page 5

 www.idatalink.com

 

For technical assistance, contact your distributor or visit www.idatalink.com/support 

© 2007 ADS Inc. 

install guide

Version française disponible en ligne au www.idatalink.com

transponder Bypass

chrysler / dodge / Jeep

Page 5 of 5

 

ADS-TBSL-C1

 

20071224

 www.idatalink.com

 

For technical assistance, contact your distributor or visit www.idatalink.com/support 

© 2007 ADS Inc. 

NOTICE:

 the manufacturer will accept no responsibility for any electrical damage resulting from improper installation of this product, be that either damage to the vehicle itself 

or to the installed device. this device must be installed by a certified technician. this guide has been written for properly trained technicians; a certain level of skill & 

knowledge is therefore assumed. please review the installation guide carefully before beginning any work.

1

2

Insert the vehicle key into the ignition.
Turn the ignition to the “ON” position.

Wait for the LED to illuminate green
for 

2 SECONDS

.

Programming is complete.

VEHICLE PROGRAMMING

ON

LED “ON” 2 SEC

1

2

NOTE

MODE SELECTION

1X

2X

PRESS

TO TOGGLE

BETWEEN MODES

PRESS + HOLD

Should you wish to change the installation mode,
follow the “Factory Reset” instructions as detailed below.

Press and release the programming button to select installation mode. 

To register selection, 
Hold the programming button down
until the LED displays a solid green light

.

OR

IDATALINK MODE

STANDARD MODE

LED flashes once

LED flashes twice

REMOTE STARTER

with Data Port

REMOTE STARTER

without Data Port

GREEN
CORRECTLY
PROGRAMMED

RED
INCORRECTLY
PROGRAMMED

1

3

4

2

DIAGNOSTICS

FACTORY RESET PROCEDURE

HOLD

When the remote starter is engaged, the LED will flash green to indicate the module 

has been correctly programmed. If the LED remains illuminated red, the device is 

incorretly programmed.

Unplug all connectors from the module.

Press and hold the programming button while inserting either 

the 4-PIN standard or 4-PIN optional iDatalink connector.

The LED will begin to flash red. Immediately release the programming button.  

The LED will turn on solid red for 2 seconds to confirm module reset.

Once  reset  is  confirmed,  plug  in  remaining  connections  and 

REPEAT PROGRAMMING PROCEDURE   

INSERT 

4 PIN CONNECTOR

UNPLUG CONNECTORS

WHEN LED FLASHES RED 

RELEASE THE BUTTON

SOLID RED LED

CONFIRMS FACTORY RESET

Doc. No.: ##00195##

Reviews: