_____________________________________________________________________
21
Co
Brite
User Manual
setting touch panel of the laser. A concurrent remote session will still be able to set the laser to
any frequency it supports.
5.2
Device Setup
Touching “Device Setup” button located in the main screen will open a popup allowing to set
device parameters.
5.2.1
“Wavel. Mode” / “Freq Mode”
toggles the base unit for setting the laser between wavelength and Frequency in the Laser
setting Popup as well as the Laser selection button located right hand side on the main screen.
5.2.2
“Trigger Config”
Defines the trigger action configuration. Press the corresponding buttons to toggle the setting.
See section 2.8 details on trigger configuration.
5.2.3
“Lock out Remote”
will block remote commands that alter the configuration of the unit to prevent interfering
commands coming in by these remote connections. A popup up to confirm the change of the
setting will be shown as potentially active remote connections will no longer be able to issue
commands. A remote connection is any access established to the unit via USB or Ethernet and
applies both to the Web-GUI and any user program.
5.2.4
“
Start Config
”
Allows configuring the Startup behavior of the
unit. “Start configuration” allows two settings:
“Factory defaults” starts the laser ports with predefined settings defined by ID Photonics.
“Last Configuration” will save the settings each time it is changed by the user and set these
upon restart of the unit.
“Laser Autostart” will allow to also set the last laser output on/off setting upon restart of the unit.
CAUTION: If enabled, the lasers may automatically switch on upon restart of the unit.
