ID Lock 202 Multi
Installation manual
V1.1
8
Mechanical function test
1.
Perform a functional test of the moving parts of the lock with the door open.
a.
Do both door handles move when using the outside and inside handle?
b.
Does the dead bolt slide in and out without friction whilst using the thumb turn knob?
c.
Can you push the sensor latch (top triangle), and does it slide nicely without
problems?
2.
If the answer is no to any of the above questions, check your installation. It may help to
lubricate the sensor latch or dead bolt slightly.
Adjusting the strike plate
The door frame should rest on the door gasket with moderate pressure. The
pressure will vary between door types.
If the gasket
doesn’t
fully seal the strike plate can be adjusted.
Use the included Allen wrench to adjust. The lower hex screw will usually
need to be tightened a bit.
IMPORTANT! If the upper screw is adjusted; make sure that the
deadbolt can move freely.
Mortise lock moving parts
The moving parts in the mortise lock is referred to as
such throughout the user manual and instructions on our
website.
1
Sensor latch
2
Dead bolt
3
Latch (for
handles)
Figure 15
–
Adjusting the strike
plate
Figure 16
–
Mortise lock moving parts
