3-14
System Installation
On/Off Power Switch Setup
*
To configure the single board computer to accommodate Omnix chassis with an
on/off switch, follow these steps:
1)
Select jumper pins 1-3 and 2-4 on JP3, AT/ATX Power Select (Figure 3-2).
2)
Make sure that JP2, ATX Power Button Interface, is not connected.
3)
Make sure that J11, ATX Power Control Connector, is not connected.
Figure 3-2. JP3, AT/ATX Power Select, Jumper Pins
* See “Wiring Diagrams” in your chassis user’s guide.
2
4
6
1
3
5
JP3
Select Jumper Pins 1-3 and 2-4