3-8
System Installation
Onboard LED Indicator
The Endeavor Plus has three LED indicators for LAN interface status.
LAN speed LED (left side) :
ON = 100Mbps activity
OFF = 10Mbps activity
LAN active LED (middle) :
ON = Tx/Rx activity
OFF = no activity
LAN Link Integrity LED (right side) :
ON = link is good in either 10 or 100 Mbps
OFF = link is bad
810e Chipset & ATA-66
A few hardware features of the 810e chipset are, by default, not recognized by Windows 95/98.
Load the 810e INF (Incremental Fix) patches to bring up the drivers so the operating system
will recognize these hardware features.
The INF driver is in the IDE/INF directory of the Endeavor Plus CD. (Note: This driver only
supports Windows 95, Windows 98, and Windows 98 Second Edition). Execute “setup.exe” to
complete the driver installation.
Also, the 810e chipset supports the ATA-66 mode, which requires the ATA-66 driver for the
real ATA-66 to function properly. The ATA-66 driver is in the IDE directory.
After installation, simply select from the Windows Start menu as “Program / Intel Ultra ATA
Storage / Companion” to bring up the user interface. Click on the device available at the left
pane and it will simply prompt the corresponding device information at the right pane.
Note:
(1) This driver only supports Windows 98, Windows 98 Second
Edition, and Windows NT 4.0. (2) For correct operation of ATA-66, use
an 80-pin IDE cable instead of a 40-pin IDE cable for IDE devices to
avoid unstable performance.
