ICS CWS-200, Operator'S Manual, Page: 7 / 20

© 2010 ICS, Blount International Inc. Specifications are subject to change without notice. REV0810 F/N 542025
TITLE CWS-200 OPERATOR’S MANUAL
7
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
• ALWAYS closely inspect the machine for worn, damaged or broken components that may
have occurred during use or due to an accidental impact or drop.
• Do NOT operate the machine if the diamond chain, guide bar and/or drive sprocket show
evidence of significant wear or damage. Replace if necessary.
• ALWAYS use genuine ICS
®
repair and replacement parts.
• Do NOT modify the machine or use components from other machines.
• ALWAYS ensure at least 20 psi (1.5 bar) water pressure is supplied to the machine.
• Avoid inserting the diamond chain into a slot narrower than the diamond segments.
Ref: The diamond segments used for the CWS-200 are .245" (6.45 mm) wide.
• ALWAYS complete the pre-cut checklist prior to each use (refer to p. 12).
• ALWAYS wear protective clothing, including hard hat, eye protection, hearing protection, and
appropriate gloves and boots.
• Avoid loose fitting clothing.
• NEVER use equipment that is poorly maintained or not functioning properly.
• ALWAYS operate and/or lift the machine with solid footing and proper positioning.
• Remove or control slurry to prevent slippery conditions in the working area.
• ALWAYS check for and remove any obstructions (plumbing, electrical conduit, air ducts, etc.)
that may interfere with the cut.
• Do NOT allow unnecessary bystanders within the working area.
• Set up a well-marked, properly organized working area with a roped boundary and clear
signs.
• ALWAYS ensure adequate ventilation when working in an enclosed area.