© 2010 ICS, Blount International Inc. Specifications are subject to change without notice. REV0810 F/N 542025
TITLE
CWS-200 OPERATOR’S MANUAL
5
SYMBOLS & LABELS
THE FOLLOWING SYMBOLS AND DEFINITIONS ARE FOUND THROUGHOUT THIS MANUAL AND
ARE DESIGNED TO MAKE YOU AWARE OF POTENTIAL HAZARDS OR UNSAFE PRACTICES
A potentially hazardous situation exists which, if not avoided,
could result in death or serious injury.
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
THE FOLLOWING SYMBOLS & LABELS MAY BE FOUND IN THIS MANUAL OR ON THE MACHINE
Read the operator’s manual carefully and understand the
contents before you use this equipment.
Always use:
• Protective helmet
• Ear protection
• Protective glasses or full face protection
Wear hand protection
WARNING
CAUTION
Valve Knob must be in
center “OFF” position
before powering on
hydraulic supply.
WARNING
F/N 541812
• Do NOT exceed hydraulic flow of 25
gpm (95 lpm) at 2500 psi (172.5 bar)
hydraulic pressure.
• Do NOT operate the machine if the
work piece, rail and/or machine are
not properly supported and secured.
• Do NOT operate with machine
directly over head.
• ALWAYS disengage the machine
from the rail before repositioning or
removing.
• Fluids escaping under pressure can
penetrate the skin.
• Failure to observe these precautions
can result in serious injury.
WARNING
F/N 541813
WARNING
• Do NOT operate the machine without side cover or guard enclosure installed.
• Do NOT tension chain, install or remove guide bar, chain or side cover without powering off hydraulic supply.
• Failure to observe these precautions can result in serious injury.
F/N 541814
1
2
3
Summary of Contents for CWS-200
Page 2: ......