© 2009 ICS, Blount Inc.
F/N 525746 Jan 09
TITLE
680GC OPERATOR’S MANUAL
6
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
• Always turn a chain-based cut-off saw OFF when performing maintenance on the saw
including diamond chain tensioning.
• Never use equipment that is not functioning properly. Have the cut-off saw repaired by
qualified service personnel.
• Turn engine OFF before refueling. Keep away from open flame. Always provide adequate
ventilation when handling fuel. Move chain-based cut-off saw at least 10 feet (3 m) away
from refueling area before starting.
• SealPro
®
diamond chains require a minimum water pressure of 20 psi (1.5 bar).
Insufficient water supply may result in excessive wear to the diamond chain, which
can lead to loss of strength and diamond chain breakage.
• Never start a chain-based cut-off saw unless the guide bar,
diamond chain and side cover are properly installed.
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothing, including hard hat, eye protection, hearing protection,
and gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on cut-off saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no
unnecessary people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases
is dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.
Summary of Contents for 680GC
Page 1: ...F N 525746 Jan 09 2009 ICS Blount Inc 680GC OPERATOR S MANUAL ...
Page 2: ......
Page 26: ......
Page 27: ......