![background image](http://html1.mh-extra.com/html/ics/680gc/680gc_operators-manual_615011016.webp)
© 2009 ICS, Blount Inc.
F/N 525746 Jan 09
TITLE
680GC OPERATOR’S MANUAL
16
OPERATION
SYSTEM CLEAN-UP
• After cutting, run the saw for at least 15 seconds with the water on to flush slurry and debris from
diamond chain, guide bar and drive sprocket.
• Wash concrete slurry from cut-off saw assembly.
• Avoid getting any water in the carburetor or exhaust system. If water enters exhaust port, point
the guide bar tip down and pull the starter handle several times to expel water from muffler.
• Remove guide bar and diamond chain. Flush out the chain tensioner with high water pressure
and lubricate with grease.
• After cleaning the cut-off saw, spray the entire saw body, diamond chain, guide bar, and drive
sprocket with lightweight oil. Using lightweight oil on the cut-off saw will minimize rust and help
reduce slurry build up.
Summary of Contents for 680GC
Page 1: ...F N 525746 Jan 09 2009 ICS Blount Inc 680GC OPERATOR S MANUAL ...
Page 2: ......
Page 26: ......
Page 27: ......