© 2012 ICS, Blount International Inc. Specifications are subject to change without notice. REV020212 F/N 549305
660GC OPERATOR’S MANUAL
6
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
• Always turn the saw OFF when performing maintenance on the saw including diamond
chain tensioning.
• Never use equipment that is not functioning properly.
• Have the saw repaired by qualified service personnel.
• Turn engine OFF before refueling. Keep away from open flame. Always provide adequate
ventilation when handling fuel. Move the saw at least 10 feet (3 m) away from refueling
area before starting.
• Diamond chains require a minimum water pressure of 20 psi (1.5 bar). Insufficient water
supply may result in excessive wear to the diamond chain, which can lead to loss of
strength and diamond chain breakage, and/or damage to the guidebar nose sprocket.
• Never start the saw unless the guidebar, diamond chain and side cover are properly
installed.
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothing, including hard hat, eye protection, hearing protection, and
gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary
people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is
dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.
Summary of Contents for 660GC
Page 2: ......