© 2012 ICS, Blount International Inc. Specifications are subject to change without notice. REV020212 F/N 549305
660GC OPERATOR’S MANUAL
23
Guidebars
• The guidebar is designed to be used on both sides. If the cut is consistently leading to one side,
turn the guidebar over to expose a new set of guide rails.
• A bench mounted belt or disc sander can be used to square the rails of a worn guidebar. A badly
worn guidebar can quickly damage a diamond chain. If the diamond chain is touching the bottom
of the guidebar groove, replace the guidebar.
• Check the guidebar for straightness. Minor adjustments can be made by bending the guidebar
slightly.
• Proper diamond chain tension will extend guidebar life. See page 9 & 10.
• Under some circumstances, especially low water pressure, the sprocket nose can wear out
before the guidebar body.
• Spray the diamond chain and guidebar with lightweight oil for storage.
• Store guidebar with the sprocket nose up.
• Periodically clean the water ports inside the groove of the guidebar using a small diameter piece
of wire.
• The guidebar is solely a guide track for the diamond chain. Never use the guidebar to lift, twist or
pry concrete material.
MAINTENANCE
Summary of Contents for 660GC
Page 2: ......
