![background image](http://html2.mh-extra.com/html/ics/660gc/660gc_operators-manual_3534845016.webp)
© 2012 ICS, Blount International Inc. Specifications are subject to change without notice. REV020212 F/N 549305
660GC OPERATOR’S MANUAL
16
SYSTEM CLEAN-UP
• After cutting, run the saw for at least 15 seconds with the water on to flush slurry and debris from
diamond chain, guidebar and drive sprocket.
• Wash concrete slurry from saw body.
• Avoid getting any water in the carburetor or exhaust system. If water enters exhaust port, point
the guidebar tip down and pull the starter handle several times to expel water from muffler.
• Remove guidebar and diamond chain. Flush out the chain tensioner with high water pressure and
lubricate with grease.
• After cleaning the saw, spray the entire saw body, diamond chain, guidebar, and drive sprocket
with lightweight oil. Using lightweight oil on the saw will minimize rust and help reduce slurry
build up.
OPERATION
Summary of Contents for 660GC
Page 2: ......