ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
25
DRAM Integrity Mode >
to choose DRAM Integrity Mode;
ECC/EC
will enable the
E
rror
C
hecking and
C
orrection DRAM
integrity mode.
DRAM Refresh Rate >
to specify the timing for DRAM Refresh
Memory Hole :
to specify the location of a memory hole in the
CMOS RAM. This setting reserve 15MB to 16MB memory
address space for ISA expansion cards that specifically require
this setting. Memory from 15MB and up will be unavailable to
the system because expansion cards can only access memory
up to 16MB.
VGA Frame Buffer USWC >
to specify whether or not a
caching of the video A000-BFFF RAM is allowed.
Enabled
will
give you better system performance.
PCI Frame Buffer USWC >
to specify whether or not a caching
of the PCI VGA frame buffer is allowed.
USWC Write Post >
to Enable or Disable the use of
Uncacheable, Speculatable, Write-Combined memory.
Graphics Aperture Size >
to define the size of Graphics
Aperture.
Search for MDA Resources >
to allow the BIOS to search for
MDA resources or not.
8bit I/O Recovery Time >
to define the length of time for 8 bit
I/O recovery.
16bit I/O Recovery Time >
to define the length of time for 16 bit
I/O recovery.
USB Passive Release >
to specify whether or not PIIX4 is
allowed to use Passive Release while transferring control data
for USB transactions.
PIIX4 Passive Release >
Enabled
will let the Passive Release
mechanism encoded when CPU to PCI bus accesses.
PIIX4 Delayed Transaction >
to enable or disable the
embedded 32-bit posted write buffer which supports delay
transaction.
USB Function >
to enable or disable the USB (Universal Serial
Bus) functions.
ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
26
4.5 Power Management Setup
Power Management/APM >
to enable or disable the Advanced
Power Management feature.
Green PC Monitor Power State >
to specify the power state of
the monitor after the specified period of display-idle has ended.
Video Power Down Mode >
to specify the power state of the
VESA VGA video subsystem after the specified period of
display-idle has ended.
Hard Disk Power Down Mode >
to specify the power state of
the hard disk after the specified period of hard drive-idle has
ended.
Standby Time Out (Minute) >
to specify the length of the
system-idle period while the system is in full power on state.
After this period of time has ended, the system will go into
Standby state.
Suspend Time Out (Minute) >
to specify the length of the
system-idle period while the system is in Standby state. After this
period of time has ended, the system will go into Suspend state.
Throttle Slow Clock Ratio >
to specify the speed of system
clock under power saving state. The figure is a ratio between
power conserving and normal state CPU clock.
Modem Use IO Port >
to assign a port for modem.
Modem Use IRQ >
to assign an IRQ for modem
Display Activity >
to specify if BIOS has to monitor display
activity or not.
Device X >
to monitor specified device IRQ or Ignore.
