ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
23
device. The Optimal and Fail-Safe default settings are
C:,A:,CDROM.
Try Other Boot Devices
> the BIOS will try to boot from any
other available device in the system if the 1
st
, 2
nd
and 3
rd
device
fails to boot.
Floppy Access Control
> to define the read/write access which
is set when booting from a floppy drive.
Hard Disk Access Control
> to define the read/write access
which is set when booting from a HDD.
S.M.A.R.T. for Hard Disks
> to allow BIOS to use the
S
ystem
Ma
nagement and
R
eporting
T
echnologies protocol for reporting
server system information on a network
BootUp Num-Lock
> to turn on/off the Num-Lock option on a
enhanced keyboard when you boot. If you turn it off, the arrow
keys on the numeric keypad can be used just as the other set of
arrow keys on the keyboard and vice versa.
Floppy Drive Swap >
this function enables you to swap the
floppy disk drives via software or without moving the hardware.
Floppy Drive Seek >
when this option is turned Enabled, BIOS
will perform a Seek command on floppy drive A: before boot-up.
PS/2 Mouse Support
> to testify whether or not a PS/2 mouse
is supported.
System Keyboard
> to configure the keyboard. If you set it
Absent, BIOS will not report keyboard errors.
Primary Display
> to define the type of display monitor of the
system. The Absent option is for network file servers.
Password Check
> to define if a password is necessary or not
for access to the BIOS setup.
Boot to OS/2
> if you run the OS/2 operating system, this option
must be set to yes. It means you permit BIOS to run properly if
OS/2 or any other OS that does not support Plug and Play is
found in your computer.
CPU Serial Number >
this option is available only if you use
Pentium
®
III processor
.
Cache Bus ECC >
this option is available only if you use
Pentium
®
III processor.
System BIOS Cacheable
> to define whether or not the
memory segment FOOOH can be read from or written to cache
ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
24
memory. Setting it Enabled will give faster execution in your
system.
XXXX, 16k Shadow
> ROM Shadow is a technique in which
BIOS code is copied from slower ROM to faster RAM. If you
enable it then the BIOS will be executed from the RAM. Each
option allows 16KB segment to be shadowed to the RAM.
4.4 Advanced Chipset Setup
This setup functions are working mostly for Chipset (Intel
440BX). These options are used to change the Chipset‘s
registers. Please carefully change any default setting ,otherwise
the system will run unstably.
Configure SDRAM Timing by SPD >
E
nabled
will select
predetermined optimal values of chipset parameters. When
Disabled, chipset parameters return to setup information stored
in CMOS.
SDRAM RAS# to CAS delay >
to specify the relative delay
between row and column address strobe form SDRAM.
SDRAM RAS# Precharge >
this option specifies the length of
time for Row Address Strobe form SDRAW to precharge.
SDRAM CAS# Latency >
to specify the CAS latency timing
form SDRAM DRAM.
