ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
29
IrDA Protocol >
to specify the function mode if an IrDA mode is
selected.
Onboard Parallel Port >
to specify the I/O port address of the
parallel port.
Parallel Port Mode >
to specify the mode of parallel port. The
options are:
Normal
(normal parallel port mode),
Bi-Dir
(supports bidirectional transfer),
EPP
(supports devices that comply with the Enhanced Parallel
Port specification),
ECP
(supports devices that comply with the Extended
Capabilities Port).
Parallel Port IRQ >
to assign certain IRQ to the parallel port.
The optimal and fail-safe settings are 7.
Parallel Port DMA Channel >
available only if the parallel port
mode is ECP. The optimal and fail-safe settings are 3.
Onboard IDE >
to define which on-board IDE controller
channel(s) to be used. Available options are: Primary,
Secondary, Both and Disabled.
4.8 Hardware Monitor Setup
There is a LM78 chip on your board which can monitor on board
system voltage and fan speed. The voltage monitoring will cover
+5V,+12V,-12V,and –5V.
ROCKY-3701 Socket 370 Celeron
TM
& Pentium III
30
Note: normal CPU Fan RPM is over than 5000 RPM. If your
CPU Fan RPM is less than that figure, something is wrong and
the CPU will be in overheat condition. Make sure that the
connection at CN3/CN16/CN17 is correct.
Change Supervisor / User Password
