ICP DAS USA PET-7060, User Manual

Page: 26 / 156

Chapter 1 Introduction
PET-7000 DIO User Manual, May 2009, V1.00, EMH-013-10----------
26
1.5.2. Connecting the Hardware
Step 1: Connect the Ethernet cable between the PET-7000 and the PoE switch.
Step 2: Check that the “RUN” LED (L1) on the PET-7000 is periodically ON for 0.5
seconds and then OFF for 0.5 seconds.
Notes:
z
Pin 8 and Pin 9 on the J2 connector are designed as VS+ and GND for the
auxiliary power input (+12 ~ +48 VDC) if the PoE switch is lacked or the total
system power requirements exceed the load capacity of user’s PoE switch.
z
NE-205PSE web page:
http://www.icpdas.com/products/Switch/industrial/ns-205pse.htm
z
Power of NS-205PSE web page:
http://www.icpdas.com/products/Accessories/power_supply/mdr-60-48.htm
Pin31
Pin30