VP-2117 Getting Started,
Apr. 2010, V1.0
3-4
3.5 Setup COM Port
’
s Baud rate & Non- Modbus Slave Port
from PAC
In this section, you can setup the baud rate of COM1/2/3. When you choose one of
the baud rates that is mean this COM Port is a Slave Port. You can also setup the
COM1/2/3 as non-Modbus Slave Port from control panel.
The COM ports which support Modbus Slave (Default baud rate setting: 19200)
COM1 (RS-232) and
One of the COM2 (RS-485),
COM3 (RS-485/RS-232, Default:
Non- Modbus Slave Port
)
The baud rate can be set between 300
、
600
、
1200
、
2400
、
4800
、
9600
、
19200
、
38400
、
57600
、
115200 bps (bit per second).
Setup COM1/COM2/COM3
’
s baud rate & Non-Modbus Slave Port :
First, power off the VP-2117 PAC, then press and hold on the F1 and F6 button,
and then power it up. In the setup mode, you will see
Dz
,
: Change the
Selection
dz
and
Dz
Enter Key is OK
dz
.
Press the or button to switch to the
Dz
Setting COM1 Baudrate
dz
/
Dz
Setting COM2 or COM3 Baudrate
dz
screen and then press to enter the
setup screen. The following description is divided into two parts COM1 and
COM2/COM3.
Setup COM1:
(Switch to
Dz
Setting COM1 Baudrate
dz
)
In the default screen (COM1 BaudRate: 19200), please press the
button to change the selection, the sequence as below:
F6
F1
Waiting any key
,
: Change the
Selection
Enter Key is OK
Back Key to Quit
Setting COM1
Baudrate
Back Key to Quit
COM1 BaudRate:
19200
: Change the selection
: Confirm
: Cancel
ГК
Атлант
Инжиниринг
–
официальный
представитель
в
РФ
и
СНГ
+7(495)109-02-08 [email protected] www.bbrc.ru