Note 1:
There are two sets encoder signals for X and Y axes. In X axis, one is from CNX
and the other is from CN5. In Y axis, one is from CNY and the other is from
CN6. Users can select encoder signals from JP1 and JP2, respectively.
Note 2:
In Z and U axes, only one set of encoder signals is used for each axis. In Z axis,
do not connect CNZ and CN7 at the same time. In U axis, do not connect CNU
and CN8 at the same time.
Note 3 :
Don’t connect NC (not connected) signals. Connecting these signals could
cause permanent damage to your motion controller.
RJ1 (The I/O signals of the FRnet)
The connectors RJ1 is an 8-pin RJ45 connector that enable you to connect to the signals of
FRnet. Fig.1-9 shows the pin assignment for the 8-pin connector on the DN-8468P, and the
Table 1-10 shows its I/O connector signal description.
Fig. 1-9 Pin definition for RJ
Note:
Don’t connect NC (not connected) signals. Connecting these signals could
cause permanent damage to your motion controller.
http:/www.icpdas.com I8094Getting Started ManualVer.2.3 2008/4/28
82