TOUCh YOUR LOGO OR WeLCOMe sCReen anYWheRe TO COnTinUe
The Main OPeRaTinG sCReen WiLL nOW aPPeaR.
The
Main OPeRaTinG sCReen
provides many options which are covered elsewhere in this manual, however
to quickly start the system you can simply accept the default water temperature setting of 15ºC or, to select a
different temperature touch the
ChanGe seTTinGs
button. Then 10ºC will be inserted automatically, but you
can change to any temperature you require at this point. simply touch the up and down arrow buttons and the
desired pool water temperature will appear on the bottom left-
hand of the screen in the blue window marked “seLeCTeD
TeMPeRaTURe”. The right-hand side of the screen shows the
outside air temperature.
The temperatures is in degrees centigrade, however it can
also be displayed in Fahrenheit. This is explained later in this
Manual.
Once you have selected the pool water temperature you want
your iCool to cool to, touch the
sTaRT
button. This takes you
back to the main run screen which is the screen that you will
use most of the time during normal operation.
sTeP 5
Touch the
sTaRT
PUMP
button. This will start the pump
operating and water should begin circulating.
nOTe! When you touch sTaRT buttons they change to sTOP
buttons and can then be used to sTOP that function if required.
iT is essenTiaL ThaT The WaTeR is FLOWinG CORReCTLY
BeFORe YOU TOUCh The
sTaRT sYsTeM
BUTTOn.
The water flow is pre set to an optimum flow of about 15-20
litres or around 3-5 gallons per minute. This allows time for the
heat exchanger to operate at maximum cooling efficiency.
Pool water is completely changed approximately every 15 to 20
minutes.
Do not touch the
sTaRT sYsTeM
button until you are sure that water is flowing smoothly. if water does not
flow smoothly within a minute or so, please check that the hose with the pump is flat on the floor and no part
of it is higher than the top of the water. Check that the water in the pool is higher than the pump. if this does
not correct the problem the system will sound an alarm and a red warning screen will appear with information
about how to correct the water flow problem.
sTeP 6
now that you have pre set your desired temperature and started the circulating pump, notice that the pump
button will have changed from
sTaRT
to
sTOP
. You can use this same button to start and stop the pump at
any time.
now, touch the
sTaRT sYsTeM
button and the cooling cycle will begin. The water will be cooled to your preset
temperature and the system will then cycle to maintain it at that temperature automatically.
The sYsTeM can
only be started once within any 3 minute period to avoid overloading the compressor. so if you don’t hear it
start do not touch the sTaRT sYsTeM again , it will start automatically after the 3 minutes safety period elapses.
if you ordered a personal logo screen your WeLCOMe screen will look like the samples below. Otherwise the
standard iCool welcome screen will appear
WaTeR TeMPeRaTURe seTTinG sCReen
sTaRT
sTaRT
sTaRT
sTaRT
sTaRT
sTaRT
10
22
22
30
15
24
Main OPeRaTinG sCReen
