Owner’s Manual Compact Range
iCoolsport.com
Page 11
aUTOMaTiC sYsTeM shUTDOWn TiMeR
You can preset your iCool to shut down at any time up to five hours in the future. This is very
convenient for coaches and specialists who may want to leave the training area early but want
to make sure that the system is not left running needlessly. To set this time, touch the
seT
shUT DOWn BUTTOn
and the clock digits on the bottom right of the screen will begin to flash
as with setting the clock. Use the same up down and left right arrows to set the number of
hours and minutes you wish to elapse before the system automatically shuts down. The system
automatically begins the countdown and will stop when the time you set reaches zero. The time
remaining before shutdown is displayed on the main clock display screen.
as the same arrows are used to set all three time functions, to avoid confusion, a red dot appears next to be
button of the function being set.
ReCOveRY sessiOn TiMeR FUnCTiOns
a very popular and useful feature of your iCool is the
sessiOn COUnTDOWn TiMeR
.
This allows you to accurately control the immersion times of athletes and to
repeat those times as often as needed. This is an essential part of successful
cryo recovery therapy and is just as important as maintaining accurate and
consistent temperatures, which of course your iCool does perfectly.
The session timer is set up from the main
TiMe seTTinG sCReen
by touching
the
seT COUnTDOWn
button. The numbers on the setting screen in the
bottom right-hand corner will begin to flash and you can use the left, right
and up, down arrows to change the time in minutes and seconds. Once you
have set the time you want your athletes to remain in the bath, touching the
DisPLaY COUnTDOWn FULL-sCReen
button will take you to the screen illustrated below. This screen allows
you to see the countdown from a distance and also to control it in various convenient ways. The current pool
temperature and the outside temperature will also be displayed.
The count down can be set for once only, or it can repeat automatically as
many times as you like. This is particularly convenient if you have a number of
athletes using the same pool at the same time. The system beeps for each of the
last five seconds at the end of each countdown to warn the athletes to get ready
to get either in or out of the pool and pauses for several seconds to allow the
changeover before the countdown begins again (if it is set in the repeat mode).
2:10
27
14
This button starts the
countdown
When this button is pressed the
countdown will repeat until the
repeat function is cancelled by
pressing once again. a red dot
indicates that it is active
Resets time to the preset
value in the single shot
mode, ready to start again by
pressing the sTaRT button
You can pause the
countdown at any time and
start again from the same
position with this button,
or touch reset to start from
the top.