icontrols PULSE, Installation Manual And Setup/User Instructions

Page: 20 / 30

20
21
OPENING SPEED
To access the Open Speed Settings, ensure you are in STARTUP MENU (see above
instructions), then toggle between options using the OPEN or CLOSE buttons until
Open Speed appears on the screen. Then press the STOP button to access and
macke changes.
The Pulse operator is factory equipped with 5 options of open speed settings,
designated as 1 (slowest) to 5 (fastest - approximately 24"/s). Toggle between
these 5 options by using the OPEN and/or CLOSE buttons, and press the Stop button once the desired selection
appears on the screen to save and return to the STARTUP menu.
CLOSING SPEED
To access the Closing Speed Settings, ensure you are in STARTUP MENU (see
above instructions), then toggle between options using the OPEN or CLOSE
buttons until Close Speed appears on the screen. Then press the STOP button to
select.
The Pulse operator is factory equipped with 5 options of close speed settings,
from 1(slowest) to 5 (fastest - approximately 16"/s). Toggle between these 5
options by using the OPEN and/or CLOSE buttons, and press the Stop button once
the desired selection appears on the screen to save and return to the STARTUP menu.
JOG MODE
To access the Jog Mode Setting, ensure you are in STARTUP MENU (see above
instructions), then toggle between options using the OPEN or CLOSE buttons until
Jog Mode appears on the screen. Then press the STOP button to begin using.
Jog Mode enables manual control of the door using the OPEN and CLOSE
buttons. During Jog Mode, all limits are de-activated, and push-hold protocols
are initiated. This selection can be used to test door functionality without the
encoder, ensure proper door balance, or as a method to operate the door under
power should the encoder malfunction. The door will travel in each direction
at the set OPEN SLOW SPEED and CLOSE SLOW SPEED (see Page 22), for safe
operation.
EXITING STARTUP MENU - CALIBRATION & TESTING
To exit from the Startup Menu, press and release the STOP button while STARTUP MENU appears on the LCD. If you
have saved changes to the operator speed, or have reset limits, you will be required to do a quick system calibration.
Screen prompts will provide real-time instruction on calibration requirements. See Page 22 for more detailed
information on Calibration.
Once Calibration is completed or if it was not required, the system will run a
quick diagnostic, and the LCD will read 'Door is Ready Press Open to Start'. This
prompt to open the door is in order to reset the encoder, and also appears
whenever there is a power reset. Once the door is opened (press the OPEN
button, door will rise at slow speed until it rests against Limit Brackets), normal
door function will resume. BEFORE OPERATING THE DOOR, ENSURE THAT THE DOOR
LIMIT BRACKETS (OR PUSHER SPRINGS OR LIMIT SWITCH) ARE IN PLACE, AND DOOR
LIMITS HAVE BEEN SET.
Testing of the door is now required. Observe whether the door is running smoothly and is stopping at the appropriate
limits. Ensure that the door is set at the required speeds, and test each reversing and activation device to confirm
their functionality.