icontrols PULSE 100 Series, User Instructions

Page: 9 / 22

8
99
Push Button and Photo-Eye Mounting
The control panel should be securely mounted
at or around eye level (minimum 5 ft. from floor)
on the same side as the operator. Ensure that the
control panel is mounted far enough away from
the door as to avoid user contact with the door
while in operation, but close enough that the user
has clear view of the door at all times. Remove
cover of Push Button Station to expose 2 mounting
holes and to obtain the mounting hardware.
The included polarized reflective photo-eye
sensor should be mounted so that it scans area
that spans the entire width of the door at a height
of no more than 6 inches from the ground. The
sensor (reflective photo-eye) should be mounted
on the operator side, while the reflector should be
mounted on the opposite side of the door, facing
the sensor so that its center meets the beam. Use
the included mounting bracket to secure to either
the door tracks or the wall. Refer to the specific
mounting details provided with the sensor. For
final alignment of the sensor, apply power to the
Operator (after complete installation - follow all
installations instructions prior to powering up).
Once properly aligned, the yellow LED indicator
on the top of the sensor will light up (and remain
lit) in confirmation.