19
26. See the CABLE DIAGRAM. Identify the High
Cable (55).
Route the High Cable (55) upward through the
Top Frame (4) and over a Pulley (48). Make
sure that the eyelet end (K) of the High Cable
is in the location shown.
Attach the Pulley (48) inside the Top Frame
(4) with an M10 x 68mm Bolt (71), two M10
Washers (57), two 13mm Spacers (52), and an
M10 Locknut (56).
27. Route the High Cable (55) over a Thin Pulley
(47) and downward through the Top Frame (4).
Attach the Thin Pulley (47) inside the Top Frame
(4) with an M10 x 68mm Bolt (71), an M10
Washer (57), and a 10mm Spacer (61). Make
sure that the Thin Pulley does not fall out of
the Top Frame while you complete steps 28
and 29.
Note: Another Thin Pulley (not shown) will be
installed inside the Top Frame (4) with the same
M10 x 68mm Bolt (71) in step 29.
25. Attach the Low Cable (53) to the U-bracket (45)
with an M6 Washer (82) and an M6 Locknut (33).
See the inset drawing. Do not overtighten the
M6 Locknut (33); it should be threaded onto
the end of the Low Cable (53) so that only
two threads are showing above the Locknut.
25
26
27
33 45
82
53
56
4
55
52
K
57
48
4
55
61 57
47
71
53
45
33
57
52
71
Summary of Contents for PRO-FORM SPORT POWER STACK XT
Page 4: ...4 all STANDARD SERVICE PLANS...
Page 30: ...30 NOTES...
