1
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON Fax: 951.689.1016
PART #
DESCRIPTION
67035
2017-UP FSD FRONT 7” BOX KIT
67035 INSTALLATION INSTRUCTIONS
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLTION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
1.
Using a properly rated jack, raise the front of the vehicle and support the frame rails with jack stands. Ensure the jack stands are
secure and set properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. Remove front wheels.
2
. Remove the sway bar links from the sway bar using an 18mm socket/wrench. Leave them connected to the differential.
[FIGURE 1]
3
. Disconnect the upper brake line brackets from the frame using a 13mm socket/wrench and lower brake line brackets from the
differential using a 10mm socket/wrench. Install new extended brake lines: Refer to the factory Ford service manual to install new
brake lines. Bleed brakes according to the instructions in your factory Ford service manual.
[FIGURE 2]
COMPONENTS INCLUDED
(1) 164027 FSD TRACK BAR BRACKET
(2) 164030 SWAY BAR DROP BRACKET
(2) 167011 FSD FRONT BUMPSTOP SPACER
(2) 168040 FSD DROP PITMAN ARM
(1) 61110 FRONT EXTENDED BRAKE LINE KIT
(1) 67035H HARDWARE KIT
HARDWARE INCLUDED
67035H HARDWARE KIT
(4) 605101 3/8-16 X 1.000 BOLT
(4) 605133 3/8” FLAT WASHER
(1) 605203 7/16-14 X 1.000 BOLT
(1) 605220 7/16-14 NYLOCK NUT
(2) 605230 7/16” FLAT WASHER
(2) 605804 M8-1.25 X 120MM BOLT
(1) 605900 1/8 X 2.000 COTTER PIN
(1) 605969 VIBRATITE RED 2ML BULLET
TOOLS REQUIRED
JACK
JACK STANDS
BRASS HAMMER
STEEL HAMMER
PLIERS
TORQUE WRENCH
3/8” SOCKET / WRENCH
1/2” SOCKET / WRENCH
5/8” SOCKET / WRENCH
3/4” SOCKET / WRENCH
15/16” SOCKET / WRENCH
10MM SOCKET / WRENCH
13MM SOCKET / WRENCH
15MM SOCKET / WRENCH
16MM SOCKET / WRENCH
18MM SOCKET / WRENCH
21MM SOCKET / WRENCH
24MM SOCKET / WRENCH
30MM SOCKET / WRENCH
46MM SOCKET / WRENCH
TECH NOTES
1. REQUIRED KITS: ICON 4-LINK KIT PN: (61560 2017-UP) OR RADIUS ARM DROP KIT PN: (64055
2017-UP) AND CASTER CAM KIT PN: (63530)
2. OEM STEERING STABILIZER IS NOT COMPATABLE WITH THIS KIT.
3. MUST FLIP DRAG LINK ON PITMAN ARM.
FIG.1
FIG.2
1-26-2018 REV.B
INSTALLATION
