1
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON Fax: 951.689.1016
PART #
DESCRIPTION
64038
2017-UP FSD ADJUSTABLE TRACK BAR KIT
64038 INSTALLATION INSTRUCTIONS
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLTION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
1
. Remove the stock track bar from the frame bracket using (2) 30mm sockets/wrenches. The vehicle may shift slightly.
2
. Remove the track bar from the ball joint taper on the axle. Using a 27mm, remove the nut and separate the ball joint using a ball
joint seperator and hammer.
3
. Connect the ICON track bar to the axle. Use a 13mm to keep the tapered stud from spinning while tightening the nut with a 27mm
socket/wrench. [Torque to factory spec]
[FIGURE 1]
4
. Loosen the pinch bolts using a 3/8” 12pt socket/wrench.
5
. Adjust the collar of the track bar while keeping the threaded bushing housing from spinning. Adjust as needed to line up in the
frame bracket.
COMPONENTS INCLUDED
(1) 164037 2017-UP FSD ADJUSTABLE TRACK BAR
(2) 167021 HEIM SPACER JM16 X .812 X 1.750
(1) 167027 LEFT/RIGHT ADJUSTER ROUND
(1) 168001 05-UP TRACK BAR BALL JOINT W/NUT
(1) 295513 JM16-1T, 1-14 LH ROD END F1 FIT
(2) 605145 3/8-16 X 1.000 12PT SCREW
(1) 605951 SPIRAL RETAINING RING
HARDWARE INCLUDED
N/A
TOOLS REQUIRED
TAPE MEASURE
BALL JOINT SEPARATOR
HAMMER
1/4” SPANNER WRENCH
TORQUE WRENCH
3/8” 12PT SOCKET / WRENCH
13MM SOCKET / WRENCH
27MM SOCKET / WRENCH
30MM SOCKET / WRENCH (2)
TECH NOTES
1. DO NOT EXCEED 3.375” OF ADJUSTMENT FROM THE CENTER OF THE ROD END TO THE EDGE
OF THE TRACK BAR PINCH HOUSING. FAILURE CAUSED BY EXCESSIVE ADJUSTMENT WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
12-7-2016 REV.A
INSTALLATION
FIG.1
