10
4. Press the other Grommet (77) into the square
hole (E) in the top of the Right Inner Upright
(126).
Then, remove the wire tie (A) from the Upright
Wire (81).
With the help of a second person, raise the Right
Upright (90) and the Left Upright (not shown).
E
77
4
5. Hold the Right Upright (90) against the Base (94).
Make sure not to pinch the Upright Wire (81).
Next, hold a Wheel (97) inside the Base (94),
and insert a 3/8" x 1 3/4" Screw (62) through
the Base and the Wheel as shown;
do not fully
tighten the Screw yet.
Next, insert two 3/8" x 2 3/8" Screws (7) with
two 3/8" Star Washers (13) and a 3/8" x 1 1/4"
Screw (63) with a 3/8" Star Washer (13) into the
bracket at the bottom of the Right Upright (90),
and partially tighten the three Screws into the
Base (94);
do not fully tighten the Screws yet.
Attach the Left Upright (not shown) and the
other Wheel (not shown) in the same way.
Note: There are no wires on the left side.
5
63
62
97
94
13
90
7
13
81
126
81
90
A
