Icom id- rp2, Instruction Manual

Page: 9 / 56

6
3
PANEL DESCRIPTIONS
ID-RP2D
■ (Front panel)
q
POWER SWITCH [POWER]
Push to turn ON the power.
The LED indicator located at right lights when the
power is turned ON.
w
HIGH/LOW POWER SELECT SWITCH [H/L]
Select either High (approximately 10 W) or Low
(approximately 1 W) output power.
e
SERVICE CONNECTOR [SERVICE]
(p. 42)
Connects a PC with an A-B type USB cable to set
the both transmit and receive frequencies.
(User supplied cable)
q w e
ID-RP2D
■ (Rear panel)
q
ANTENNA CONNECTOR [ANT]
(p. 10)
Connect the optional AH-108 1.2 GHz Collinear
antenna.
When both the ID-RP2D and ID-RP2V is com-
posed in a site, an antenna filter, such as band-
pass filter, resonator, or so, should be installed be-
tween the ID-RP2D and antenna to protect the ID-
RP2D reception from interference of the ID-RP2V
downlink signal.
w
COOLING FAN
e
POWER CONNECTOR [DC13.8V]
(p. 10)
Connects to the ID-RP2C with the supplied DC
power cable
(OPC-1309)
to be supplied the DC
power.
r
[CONT I/O]
(p. 10)
Connects to ID-RP2C with the supplied control
cable for received or transmitted serial data com-
munication.
t
GROUND TERMINAL [GND] (p. 9)
Connects to a ground to prevent electrical shocks,
TVI, BCI and other problems.
q w e r t