Icom id- rp2, Instruction Manual

Page: 46 / 56

43
7
REPEATER SETTINGS
2001 NEW 2001 NEW
Frequency setting for ID-RP2V
■
NOTE:
The repeater unit connection may not be recog-
nized with the PC according to the using USB cable
length.
Use the shorter USB cable as possible is recom-
mended.
q
Start up the PC.
w
Connect a PC’s USB port and the ID-RP2V [SER-
VICE] connector with an A-B type USB cable
(User
supplied)
, then turn the ID-RP2V power ON.
• Connect a USB cable to [SERVICE R] when setting re -
ceive frequency.
• Connect a USB cable to [SERVICE T] when setting
transmit frequency.
e
Start up the ID-RP2V/D utility software.
Double click the “ID-RP2VD” icon on the desktop
or select the “ID-RP2VD” in “Program” in “Start”
menu.
r
The screen as at left appears, then the dialog
below is displayed.
• Click [OK].
NOTE:
The screen, described in steps
t
, appears
instead of these screens when the correct COM
port number is set.
• Click <Option (O)> menu then select <COM Port(P)…>.
Enter the allocated number of the ID-RP2V [SERVICE]
connector then click [Apply] in the displayed “COM Port
Setting” screen.
Enter the COM port number.
Click
NOTE: See pages 29 to 32 for the COM port num-
ber confirmation details.
w
Click
q
Enter the speci-
fied frequency.
t
The utility software reads the ID-RP2V setting and
the screen as at left appears when the correct
COM port number is set.
y
Enter the specified receive and transmit frequen-
cies into “RX/TX Frequency” column.
u
Click [Write] to program the set frequencies into
the ID-RP2V.