Icom id- rp2, Instruction Manual

Page: 8 / 56

3
5
PANEL DESCRIPTIONS
2001 NEW
ID-RP2C
■ (Front panel)
q
POWER SWITCH [POWER]
Push to turn ON the power.
The LED indicator located at right lights when the
power is turned ON.
w
10BASE-T CONNECTOR [10BASE-T]
(p. 38)
Connects a PC with LAN cable to set the details of
the repeater site, such as the call sign, IP address.
A Gateway server can also be connected to this
connector.
e
SERVICE 1 CONNECTOR (p. 44)
Connects a PC with an A-B type
USB cable
(User
supplied cable) to set the operating frequency or
monitor the repeater operation for the microwave
link repeater that is connected to an [ASSIST1]
connector.
r
SERVICE 2 CONNECTOR (p. 44)
Connects a PC with an A-B type USB cable (User
supplied cable) to set the operating frequency or
monitor the repeater operation for the microwave
link repeater that is connected to [ASSIST2] con-
nector.
t
ASSIST 1 SWITCH
Turns the microwave link repeater power ON and
OFF, that is connected to [ASSIST1] connector.
The LED indicator located at right lights when the
power is turned ON.
y
ASSIST 2 SWITCH
Turns the microwave link repeater power ON and
OFF, that is connected to [ASSIST2] connector.
The LED indicator located at right lights when the
power is turned ON.
q w e r t y
ID-RP2C
■ (Rear panel)
q
POWER CONNECTORS
[LOCAL RPT— DC13.8V OUT]
(p. 10)
Outputs 13.8 V DC for local repeater.
Connects the ID-RP2D/V with the supplied DC
power cable
(OPC-1309; supplied with the ID-RP2D/V)
.
The same voltage as the supplied voltage to
[DC13.8V IN] connector is output regardless of the
[POWER] switch condition on the front panel.
w
[LOCAL RPT— CONT I/O]
(p. 10)
Input/output ports for local repeater to received or
transmitted serial data routing.
Connects the ID-RP2D/V with the supplied control
cable
(supplied with the ID-RP2D/V)
.
e
DC POWER CONNECTOR
[ASSIST 1— DC 13.8V OUT]
Connects the ID-RP2L’s power cable.
The DC power is turned ON and OFF with [AS-
SIST 1] switch on the front panel.
r
ASSIST 1— A/B
(p. 10)
Connects the ID-RP2L’s data cable.
Connects data cable connector [A] to left and data
cable connector [B] to right connector.
t
DC POWER CONNECTOR
[ASSIST 2— DC 13.8V OUT]
Connects the ID-RP2L’s power cable.
The DC power is turned ON and OFF with [AS-
SIST 2] switch on the front panel.
y
ASSIST 2— A/B (p. 10)
Connects the ID-RP2L’s data cable.
Connects data cable connector [A] to left and data
cable connector [B] to right connector.
u
POWER CONNECTOR [DC 13.8V IN] (p. 10)
DC power input connector for the ID-RP2 system.
Connects a 13.8 V DC power supply unit with the
DC power cable
(OPC-1380; supplied with the ID-
RP2C)
.
i
GROUND TERMINAL [GND]
(p. 9)
Connects to a ground to prevent electrical shocks,
TVI, BCI and other problems.
q w e u t i r y