Icom ID-RP1200VD, Instruction Manual

Page: 9 / 24

4
PANEL DESCRIPTION
2
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
1
1
CONT I/O PORT [CONT I/O]
(p. 15)
Connects to the ID-RP2C with the supplied control
cable for serial data communications.
L
Not usable in DD mode.
2
REFERENCE SIGNAL INPUT CONNECTOR
[REF IN 10 MHz]
(p. 16)
Inputs a 10 MHz reference signal for adjusting the
reference signal.
3
RPT1/RPT2 PORT [RPT1]/[RPT2]
(p. 16)
Connects to other repeaters with the supplied
control cable for data communications, when
additional repeater modules are installed in the
local repeater.
4
USB PORT [USB]
(p. 16)
Connects to a PC through a USB cable (A - B type)
to program the repeater.
5
CONT I/O RPT SWITCH [CONT I/O RPT]
(p. 8)
Select to use the [RPT1]/[RPT2] or [CONT I/O].
When using the ID-RP2C as gateway or assist
controller, set to [CONT I/O].
L
Turn the repeater OFF and then restart it to apply the
change.
6
DV/DD SELECT SWITCH [DV/DD]
(p. 7)
Select an operating mode from DD mode or DV
mode.
7
SERVICE JACK [SERVICE]
(p. 16)
Outputs the receive audio and DTMF tones.
8
GROUND TERMINAL [GND]
Connects to a ground to prevent electrical shocks,
TVI, BCI and other problems.
9
TX ANTENNA CONNECTOR [TX ANT]
(p. 16)
Connects to a 50 Ω transmit antenna.
L
In DD mode, the connector is used as a both TX and
RX antenna connector.
10
POWER CONNECTOR [DC13.8V]
(p. 15)
Connects to a 13.8 V DC through the supplied DC
power cable.
11
RX ANTENNA CONNECTOR [RX ANT]
(p. 16)
Connects to a 50 Ω receive antenna.
L
In DD mode, the connector is not used.
1 2 3 4 7 5 6 8
9 10 11
ID-RP1200VD: