Icom ID-RP1200VD, Instruction Manual

Page: 15 / 24

10
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
1
2
3
4
SD CARD
LOCK
SD
NOTE:
• Before using the SD card, thoroughly read the
instructions that comes with the card.
• If any of the following occur, the SD cardʼs data may be
corrupted or deleted.
-Drop, impact, or vibrate the SD card.
-Removing from the repeater while it is turned ON.
- Removing from the repeater while it is still accessing
the SD card.
• Do not touch the contacts of the SD card.
• The repeater may take a longer time to recognize the
SD card with larger storage.
• The SD card has a certain lifetime. Data reading or
writing may not be possible after using it for a long
years.
• Icom will not be responsible for any damage caused by
data corruption on an SD card.
D
Inserting
Insert the SD card as shown below.
L
Insert the SD card into the slot until it locks in place, and
makes a ‘click’ sound.
L
Be sure to check the card orientation before inserting.
NOTE:
•Format the SD card on your PC before inserting.
• Before formatting, backup its data onto your PC.
Formatting a card erases all its data.
• When inserting, folders will be created on the SD card.
IMPORTANT:
Even if you have formatted an SD
card, some data may remain in the card. When you
dispose the card, be sure to physically destroy it to
avoid unauthorized access to any data that remains.
LOCK
SD
■
Using an SD card
You can use an SD card of up to 2 GB, or an SDHC of
up to 32 GB. Icom has checked the compatibility with
the following SD and SDHC cards.
Manufacturer Type Storage
SanDisk
®
SD 2 GB
SDHC 4/8/16/32 GB
L
The above list does not guarantee the card’s
performance.
L
Throughout the rest of this document, the SD cards and
SDHC cards are simply called the SD card or the card.
The repeater uses the data saved in following formats:
• The repeaterʼs setting data (icf).
• The voice data used for reading out callsign (wav).
• Firmware data for update (dat).
An SD card is required when:
• Updating the repeaterʼs firmware.
• Importing or exporting the repeaterʼs setting data*.
• Importing the voice data used for reading out
callsign*.
* The Utility for ID-RP3 is required. Ask your dealer for
details of the utility.
q
w
D
Removing
Push in the SD card until a ‘click’ sounds to unlock
(
1
), and then remove it from the slot (
2
).