Icom IC-R75, Instruction Manual

Page: 5 / 46

3
2
PANEL DESCRIPTION
!1
MEMORY CHANNEL UP/DOWN SWITCHES
[
√ √
DN]/[UP
∫ ∫
] (p. 21)
➥
Select a memory channel.
➥
Select a set mode contents while in set mode.
➥
Select a timer or time indication while in clock in-
dication.
➥
Select a filter set mode contents while in filter set
mode.
!2
MEMORY WRITE SWITCH [MW] (pgs. 22, 27)
➥
Stores the displayed frequency and operating
mode into the selected memory channel when
pushed for 2 sec.
➥
Toggles the programmed scan and auto memory
write scan when pushed.
!3
CLEAR SWITCH [CLR] (p. 24)
➥
Clears the input digits while inputting a frequency
or memory channel number.
➥
Clears the selected memory channel contents
when pushed for 2 sec. in memory mode.
• This switch does not function in VFO mode.
!4
VFO/MEMORY SWITCH [V/M] (pgs. 21, 23)
➥
Toggles the operating mode between VFO mode
and memory mode when pushed.
➥
Selects a memory channel for inputting a mem-
ory channel number when pushed.
➥
Transfers the memory contents to VFO when
pushed for 2 sec.
!5
KEYPAD (pgs. 11, 21)
The keypad can be used for several functions as
below:
• Keypad then [ENT]
— Direct frequency input.
• Keypad then [V/M]
— Memory channel selection.
• [ENT] then keypad in memory name indication
mode
— Alphanumeric input for memory name, etc.
!6
QUICK TUNING STEP SWITCH [TS] (pgs. 12, 13)
➥
Selects a quick tuning step or turns the quick tun-
ing step OFF.
• While the quick tuning indicator (
"
)
is displayed, the
frequency can be changed in kHz or MHz steps.
➥
While the quick tuning step is OFF, turns the 1 Hz
step ON and OFF when pushed for 2 sec.
• 1 Hz indication appears and the frequency can be
changed in 1 Hz steps.
➥
While the kHz quick tuning step is selected, en-
ters tuning step set mode when pushed for 2 sec.
➥
While the memory name indication is selected in
memory mode, pushing this switch shows the op-
erating frequency; and rotating the tuning dial
while pushing this switch changes the frequency
temporally.
!7
FILTER SWITCH [FIL] (pgs. 18, 19)
➥
Push momentarily to toggle between the pre-pro-
grammed normal, wide and narrow IF filters for
the selected operating mode.
➥
Push for 2 sec. to enter filter set mode.
!8
MODE SWITCHES [SSB]/[CW/RTTY]/[AM]/[FM]
(p. 14)
Select an operating mode.
• Push [SSB] to toggle between LSB and USB.
• Push [CW/RTTY] to toggle between CW and RTTY.
• Push [CW/RTTY] for 2 sec. to toggle between CW and
CW reverse or RTTY and RTTY reverse.
• Push [AM] to toggle between AM and S-AM.
• Push [FM] to select FM.