4
11
FREQUENCY SETTING
■
Read me first
The receiver uses memory channels for storage of fre-
quencies (as well as mode, tuning steps, etc.). When
turning power OFF or changing memory channels, the
previously displayed frequency cannot be recalled un-
less it has been stored into a memory channel.
Therefore, when you want to keep a displayed fre-
quency for later recall, you must program it into a
memory channel by pushing [MW] for 2 sec.
See p. 22 for details.
■
Using the keypad
q
Push the numeral keys on the keypad to enter the
MHz digits for the desired frequency.
• If a key is mistakenly pushed, push [CLR] and start
again from the beginning.
• When entering the same MHz digits as the displayed
frequency, this step can be skipped.
w
Push [•] on the keypad.
e
Push the numeral keys to enter the frequency digits
below 1 MHz.
• If a key is mistakenly pushed, push [CLR] and start
again from the beginning.
r
Push [ENT] to set the input frequency.
• When pushing [ENT] after entering the MHz digits, zeros
are automatically entered for the kHz digits.
BLANK
BLANK
S1
3
5
7
9
20
40
60dB
AGC
ANT
USB
R X
V F O
1
“BLANK” appears above the memory channel
readout until [MW] is pushed for 2 sec.
Push [MW] for 2 sec. after tuning.
[EXAMPLE]: Setting the frequency using the keypad.
USB
R X
USB
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
USB
R X
1
5
JKL
8
TUV
.
.
.
0
QZ
5
JKL
8
TUV
USB
R X
0
QZ
•To set to 28.00 MHz
2
ABC
8
TUV
ENT
5
JKL
ENT
•To set to 21.050 MHz
2
ABC
•To set to 850 kHz (0.850 MHz)
ENT
ENT
•To change 14.19075 to 14.850 MHz
