![background image](http://html1.mh-extra.com/html/icom/ic-m803/ic-m803_instruction-manual_2038025021.webp)
13
BASIC OPERATION
5
5
■
Receiving and transmitting
D
Receiving
1� Select a channel by rotating [CH/GRP], or pushing
the Keypad keys� (p� 12)
2� When receiving a call, rotate [VOL] to adjust the
audio output level�
TIP:
When a call is received:
•
is displayed�
• You can hear received audio from the speaker�
• The S-meter displays the received signal strength�
D
Transmitting
1� Select a channel by rotating [CH/GRP] or pushing
the Keypad keys� (p� 12)
2�
Pus
or
until
is displayed in the
Software Key area�
3� Hold down
to temporarily monitor the
transmit frequency of the selected channel�
•
blinks while holding down�
NOTE:
If the channel is busy, wait until it
becomes clear, or change to another channel�
4� Hold down [PTT] on the handset and speak into
the microphone at your normal voice level�
•
is displayed while transmitting�
NOTE:
If “SWR” is displayed during the
transmission, check your antenna system�
5� Release [PTT] to receive�
•
is displayed�
NOTE:
The Time-out Timer function cuts OFF
transmission after 16 minutes of continuously
transmitting�
TIP:
To maximize the readability of your transmitted
signal, pause for a second after holding down [PTT]�
Hold the microphone 5 to 10 cm (2 to 4 inches) from
your mouth, and then speak at your normal voice
level�
■
DSC Scan
To receive a DSC call, such as an Individual call or a
Group call, push [D-SCAN] to enter the DSC watch
mode�
DSC watch mode
[CH/GRP] [VOL]
Software Keys
[D-SCAN]
NOTE:
The following frequencies are always
automatically monitored with this transceiver�
2187�5, 4207�5, 6312�0, 8414�5, 12577�0, and
16804�5 kHz
L
The setting for monitoring these frequencies can be
changed in the Scanning Receiver setting� (p� 56)
Keypad
keys
Summary of Contents for IC-M803
Page 91: ...83 252 9 29 32 95 4 3 3 4 R8 5 16 Maximum 274 10 25 32 114 4 1 2 Unit mm inch Cut here...
Page 92: ......
Page 95: ...MEMO...