v
QUICK REFERENCE
2001 NEW
2001 NEW
■
Basic voice transmission and reception
D
Receiving a signal
q
Select the desired channel using [GRP] and [CH],
or the keypad.
• Turn the squelch function ON and OFF, or adjust the
squelch level as desired.
w
When a signal is received, the “
RX
” indicator ap-
pears and audio is heard from the connected
speaker.
• Rotating [VOL] to adjust the audio output level at this
step is recommended.
• The S-meter shows the received signal strength.
e
Use the following functions, if desired:
• Noise blanker
Push [
F
] then [1
nb
] to turn the noise blanker
ON or OFF.
• “
NB
” appears when the noise blanker is activated.
• See page 50 for the noise blanker level adjustment.
• AGC (Automatic Gain Control) OFF function
Push [
F
] then [5
agc
×
] to turn the AGC OFF
function ON or OFF.
• “
A G C
” appears when the AGC-OFF function is ac-
tivated (deactivating the AGC).
• RF gain level
Push [
F
], [6
rf-g
] to enter the RF gain adjust-
ment mode, then rotate [CH] to adjust the gain.
• Set the gain to between 0 (low sensitivity) and 9
(maximum sensitivity).
• Push [MODE
set
] to exit the adjustment mode.
• Clarity
Push [
F
], [RX
clar
] to switch the clarity func-
tion ON or OFF, then rotate [CH] for fine tuning.
[5
AGC
×
]
[1
NB
]
[
F
] [RX
CLAR
]
[6
RF-G
]
D
Transmitting in voice
q
Select the desired channel using [GRP] and [CH],
or the keypad.
w
Push [
F
], then hold down [TX
txf
] to temporar-
ily monitor the transmit frequency of the selected
channel.
• The transmit frequency is displayed and “
TX
” blinks.
• If the channel is busy, wait until it becomes clear, or
change to another channel.
[TX
TXF
]
[GRP] [CH]
[
F
]
e
Push [
F
] then either [7
Lo
], [8
Mid
] or [9
Hi
] to select
low, middle or high output power, respectively.
[8
Mid
]
[7
Lo
]
[
F
]
[9
Hi
]
r
When the optional AT-140 is connected, push
[TUNE
thru
] to start tuning.
• “
TUNE
” appears when the antenna is tuned.
• “
TUNE
” blinks when a tuning error has occurred.
• Automatic tuning can also be done.
[TUNE
THRU
]
t
Hold down [PTT] on the microphone to transmit.
• “
TX
” appears.
• If “
SWR
” appears during transmit, check your antenna
system.
y
Speak into the microphone at your normal voice
level.
u
Release [PTT] to return to receive.
• “
TX
” disappears.
Summary of Contents for IC-M802
