![background image](http://html1.mh-extra.com/html/icom/ic-m605/ic-m605_instruction-manual_2037993108.webp)
98
98
12
CONNECTIONS AND MAINTENANCE
■
Microphone installation
Connect the supplied or optional HM-205 and the optional
HM-195*
1
/HM-229 to the transceiver using the connection
cable that comes with the transceiver or the microphone.
The cable is required to operate the transceiver from a
longer distance. You can also install the cable connector as
a built-in plug on a cabinet or wall.
To operate from even longer distances, connect the optional
6 meter long OPC-1541 extension cable between the
transceiver and the microphone.*
2
Up to two OPC-1541 can
be added.
*
1
Not usable for the IC-M605EURO.
*
2
OPC-2384
coversion
cable
is required to connect the transceiver
and HM-195/HM-229 command microphone or OPC-1541
extension cable.
NOTE:
The firmware of HM-195/HM-229 may be update
when you connect them to the transceiver.
D
Installation
1. Insert the connection cable connector into the
microphone connector or the command microphone
jack, and tighten the nut.
2. To use the cable connector as a wall socket, install it as
shown to the right.
3. Using the mounting base as a template, carefully
mark the holes where the cable and 3 screws will be
fastened.
4. Drill holes at these marks.
5. Install the mounting base using the supplied screws, as
shown below.
•
HM-205
Mounting base
Nut
Cap
Gasket
Screw holes
(approximately 2 (d) mm,
1
/
16
inch)
•
HM-195/HM-229
Mounting base
Nut
Cap
Gasket
Screw holes
(approximately 2 (d) mm,
1
/
16
inch)