![background image](http://html.mh-extra.com/html/icom/ic-m503/ic-m503_insrtuction-manual_612817039.webp)
35
12
HM-134 REMOTE-CONTROL MICROPHONE
■
Call channel programming
q
While pushing and holding [H/L],
push [DIAL] several times to select
the desired channel group (USA or
INT) to be programmed.
w
Push and hold [16•C] for 1 sec. to
select the call channel of the se-
lected channel group.
• “CALL” and call channel number ap-
pear.
e
Push and hold [16•C] again for
3 sec. (until long beep changes to
2 short beeps) to enter call channel
programming condition.
• Call channel number and channel
group to be programmed flashes.
r
Push [
Y
]/[
Z
] to select the desired
channel.
t
Push [16•C] to program the dis-
played channel as the call channel.
• The call channel number and channel
group stop flashing.
■
Optional voice scrambler
operation
ï
ï
Activating the scrambler
q
Select an operating channel, other than Channel 16.
w
While pushing and holding
[H/L], push [DUAL] to turn
the voice scrambler function
ON.
• “SCRM” appears.
e
To turn the scrambler func-
tion OFF, repeat step
w
.
• “SCRM” disappears.
ï
ï
Programming scramble codes
There are 128 codes (00 to 127) available with UT-98 or 32
codes (01 to 32) available with the UT-112 for programming.
In order to understand one another, all transceivers in your
group must have the same scrambler code, as well as the
same scrambler unit. The scrambler code is programmed in
set mode. See pgs. 10, 16, 37 for details.
Appears when the voice
scrambler function is in use.
01 IC-M503-(1).qxd 01.12.17 5:00 PM Page 35 (1,1)