![background image](http://html.mh-extra.com/html/icom/ic-m200/ic-m200_instruction-manual_612739010.webp)
7
3
BASIC OPERATION
■
Setting a Call channel
■
Entering a channel name
The Call channel is used to select Channel 9 (default).
However, you can set another channel as the Call
channel in each channel group.
1. Push [
Ù
] and [
Ú
] on the transceiver at the same
time to select the desired channel group. (p. 5)
2. Hold down [16/C] for 1 second to select the Call
channel of the selected channel group.
•
“
CALL
” and Call channel number is displayed.
3. Hold down [16/C] again for
3 seconds (until a long beep
changes to 2 short beeps) to
enter the Call Channel Set
mode.
•
Channel number blinks.
4. Push [
Ù
] or [
Ú
] to select the
desired channel.
5. Push [16/C] to set the
displayed channel as the Call
channel.
•
2 short beeps sound.
•
The channel number stops
blinking and the setting is
saved.
L
Push [CHAN] to cancel setting.
You can enter a channel name of up to 10 characters
each. A name with more than 6 characters is scrolled
after you select a channel.
L
You cannot enter a channel name to 4 digit
channels.
L
Capital letters, small letters (except f, j, k, p, s, v, x,
z), 0 to 9, some symbols (= * + – . /) and space can
be used.
NOTE:
Cancel Dualwatch, Tri-watch or Scan in
advance.
1. Select the desired channel.
2. While holding down [CHAN],
push [16/C] to edit the channel
name.
• A cursor and the first character
alternately blink.
3. Push [
Ù
] or [
Ú
] to select the desired character.
L
Push [16/C] or [CHAN] to move the cursor forward or
backward.
4. Repeat step 3 to enter all characters.
5. Push [DW] to save the channel name.
•
The cursor and the character stop blinking.
L
Push [SCAN] to cancel the editing.