![background image](http://html.mh-extra.com/html/icom/ic-e208/ic-e208_instruction-manual_612424039.webp)
24
4
REPEATER OPERATION
4
■
Offset frequency
[
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
q
Push [BAND] to select the desired frequency band.
w
Select the desired mode/channel you wish to set the offset
frequency, such as VFO mode or memory/call channel.
• The offset frequency can be independently programmed into
each mode or channel.
e
Push [SET•LOCK] to enter set mode.
r
Push [SET•LOCK] or [S.MW•MW] until “DUP” and offset
frequency appear.
t
Rotate [DIAL] to set the desired offset frequency.
y
Push [V/MHz•SCAN] to exit set mode.
z
Push [BAND] to select the desired frequency
band.
• Enter the desired frequency via the keypad if neces-
sary.
x
Select the desired mode/channel you wish to
set the offset frequency, such as VFO mode or
memory/call channel.
• The offset frequency can be independently pro-
grammed into each mode or channel.
c
Push [
SET
B(D-OFF)] to enter set mode.
v
Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] until
“DUP” and offset frequency appear.
b
Push [
Y
] or [
Z
] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
n
Push [
CLR
A(MW)] to exit set mode.
☞
NOTE:
The offset frequency can be set in a memory/call
channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
Push
SET
B
[SET•LOCK]
“DUP” and offset frequency appear