![background image](http://html.mh-extra.com/html/icom/ic-756proiii/ic-756proiii_instruction-manual_612299062.webp)
57
5
FUNCTION FOR RECEIVE
■
Preamplifier
The preamp amplifies received signals in the front
end circuit to improve the S/N ratio and increase the
sensitivity. Set this to preamp 1 or preamp 2 when re-
ceiving weak signals.
➥
Push
[P.AMP]
several times to set the preamp
OFF, preamp 1 ON or preamp 2 ON.
• “P. AMP1” activates 10 dB preamp for HF all bands.
• “P. AMP2” activates 16 dB high-gain preamp for
24 MHz band and above.
Regarding the use of the “P.AMP 2”
(Pre-amplifier 2)
The “P.AMP 2” is a high gain receive ampli
fi
er. When
the “P.AMP 2” is used during times of strong electric
fields, distortion sometimes results. In such cases,
use the transceiver with the “P.AMP 1” or “P.AMP
OFF” setting.
The “P.AMP 2” is most effective when:
• Used on bands above 24 MHz and when electric
fi
elds are weak.
• Receive sensitivity is insuf
fi
cient during low gain, or
while using a narrow band antenna (such as small
loop, a Beverage antenna or a short Yagi antenna,
etc.) is used.
[P.AMP]
■
Attenuator
The attenuator prevents a desired signal from distor-
tion when very strong signals are near the desired fre-
quency or when very strong electric fields, such as
from broardcasting stations, are near your location.
➥
Push
[ATT]
several times to set the attenuator 6
dB, 12 dB, 18 dB or OFF.
• “ATT 6dB,” “ATT 12dB,” “ATT 18dB” and “ATT OFF” ap-
pears respectively.
[ATT]